Not sure where I’m going wrong, Crazy fails.

Took a break from 3-D printing because it felt like I just kept encountering problem after problem, but I have decided to not go down and just troubleshoot everything until I can get the hang of it. These last couple fails have just been crazy and I’m really not even sure what steps to take to course correct any advice would be greatly appreciated!

My printer is an Elegoo Mars 2 Pro And I’m using ABS like Grey resin

I have re-leveled the build plate between each print

I upgraded my thumb drive and make sure it was formatted correctly

The room is with in the correct temperature range, and I have even gone so far warm the resin on the last print

It looks like the model is getting stretched, but it doesn’t show it on the slicing software

Any ideas?