DIY Sex Doll cleaner
Thought some might find this interesting. It's a 1 gallon sprayer pushed through a T connector.
You pump it up, push the thing against the hole, and spray. It can be tricky getting a seal (Mark 2 will probably have some kind of splayed angle thing) but water goes in, then the waste flows back into the T connector and down out the hose which goes into a bucket or drain. The sprayer goes through a rubber bung(?) so the waste doesn't go out the back.
Not sure I explained it well, but figured some people might find it helpful. I actually have the electric one that came with my Zelex, but it doesn't hold much water and I always felt like I had to fill it twice for each hole I used. I ended up using an enema bulb, but the waste water was sometimes hard to manage, plus it also didn't hold much.
This has the best of a lot of worlds. Relatively portable, clean, and lots of water. The waste hose is an overkill re-inforced one, I only used it because its outer diameter was a friction fit inside the t-connector and there were no other options at lowes.
Thought some might find this interesting. It's a 1 gallon sprayer pushed through a T connector.
You pump it up, push the thing against the hole, and spray. It can be tricky getting a seal (Mark 2 will probably have some kind of splayed angle thing) but water goes in, then the waste flows back into the T connector and down out the hose which goes into a bucket or drain. The sprayer goes through a rubber bung(?) so the waste doesn't go out the back.
Not sure I explained it well, but figured some people might find it helpful. I actually have the electric one that came with my Zelex, but it doesn't hold much water and I always felt like I had to fill it twice for each hole I used. I ended up using an enema bulb, but the waste water was sometimes hard to manage, plus it also didn't hold much.
This has the best of a lot of worlds. Relatively portable, clean, and lots of water. The waste hose is an overkill re-inforced one, I only used it because its outer diameter was a friction fit inside the t-connector and there were no other options at lowes.