PSA DO NOT TIGHTEN NOZZLE on Ender-3 V3 SE/KE Ceramic Heating Block Kit (unicorn nozzle kit)

If you do you will strip the two small M2 screws and holes noted in the picture rendering the nozzle unusable. Either the heat brake on the nozzle acts like a gear puller when it contacts the stop inside the heat sink or the nozzle does the same to the attachment ring.

This is a serious design flaw given how the stock nozzle needs to be tightened to prevent leaks. The entire heat block is held on by a tiny amount of thread on two M2 screws.

Nowhere in the instructions is KE assembly shown and neither is not tightening the nozzle when changing nozzles.

TL;DR DO NOT TIGHTEN THE NOZZLE after it “touches down” screwed inside the assembly.

Creality: if you’re reading this you owe me two replacement units. Messaged and emailed you about yours last week with no response rece