Anycubic Basic PLA Setting Recommondations?
Hi Everyone,
I Just recently bought 3kg of Anycubic PLA Basic Spools from my mini factory at a discount, but the generic setting for PLA from bambu studio is having issues, I was wondering if anyone has any experience with the material and could give any advice on what settings to use for it?
(The issues in question being the filament shrinking off the build plate and the filament not flowing correcltly, could be a print speed issue but I'm not sure)
Hope you're all doing good!
Edit: seems like slowing it down saved the print! the filiment might just have a slower flow rate than normal pla plastic?
But ill an update in in 7ish hours if it failed again or not lol
Edit 2: it works fine after slowing it down! Ive washed the plate each time/ properly cleaned things up each time prior, the room is fairly cold so it could be shrinking faster? But after putting it on 50% its all sorted! :)